ALM Code 7 Milled Lead - 450mm x 3m 
Everbuild Showerproof Bathroom Silicone - Clear 280ml (Box of 12) 
OX Tools Pro PolyZip 4 Piece Cutter Set - (15, 22, 35, 42mm) 
Soudal Repair Express Plaster - White 900ml 
Bond It Cover-It Hardfloor & Glass Protector - Blue 625mm X 50M 
ALM Code 8 Milled Lead - 1600mm x 3m 
Ronseal Exterior Multi-Purpose Smooth Finish Filler - Grey 330g 
Thompson's Patio & Block Paving Anti-Slip Additive - 200g 
Ronseal Stays White Ultra Tough White Gloss Paint - 2.5L 
Code 6 Cast Lead - 1200mm x 6m 
Everbuild Everflex 200 Contractors LMA Silicone - Brown 295ml 
FloPlast Round Line Downpipe Clip, Brown 
Code 7 Cast Lead - 210mm x 3m 
Code 5 Cast Lead - 800mm x 3m 
Ronseal Diamond Hard Floor Varnish - Clear Matt 5L 
Soudafoam Window & Door Hand Held - 750ml 
ALM Code 6 Milled Lead Flashing - 390mm x 6m 
Timco Copper Disc Rivets 
Code 4 Cast Lead - 600mm x 3m 
Samac Copper Wire Coil 36m x 2mm 
OX Trade Hard Green Carpenters Pencils – Pack of 10 
Uses
This Everbuild All Purpose Ready Mixed Filler is essential for any D.I.Y enthusiast or Tradesman looking to repair various surfaces. This product dries to a smooth but tough, crack-resistant sandable finish, allowing you to perfectly repair a hole to a flush finish. This product is suitable for internal and external use, offering various areas of applications; this product is suitable for surfaces such as;
- Plaster
- Brick
- Wood
- Stone
- Render
Preparation
You must prepare all surfaces correctly to achieve a good key and optimal adhesion. Remove any dust, oil, dirt, grease or similar contaminants, cover any nail or screw heads with oil-based paint and allow to dry.
Application
- Stir well before use and apply directly from the tub into the filling area.
- This product can fill a gap with a maximum depth of 9mm. If you want to fill a more significant depth, apply in layers and allow 1 hour between each layer so it can fully cure.
Limitations
- Do not use to fill plastics or metals.
- This product is unsuitable to be applied when rain is imminent or within 5 hours of application.
- Do not apply in temperatures below 5°C.
- Not suitable for repairs in permanently wet areas
- Do not apply more than 9mm depth per application. (e.g. if the gap is 27mm deep, it will take 3 coats at 9mm depth each with an hour between each one)
