Easy-Trim Over Fascia Vent - 10mm x 500mm (Box of 60) 
ALM Code 7 Milled Lead - 390mm x 3m 
Everbuild EuroScrim Plasterboard Tape – 100mm x 90m 
Hambleside Danelaw TV15/1 Flush Fitting Tile Vent - Slate Grey (Box of 5) 
Everbuild Forever Clear Silicone Sealant – 295ml (Box of 12) 
Code 7 Cast Lead - 390mm x 3m 
Everbuild Safer Spirit - 750ml 
Soudal 140 LQ Contact Adhesive – 5 Litre 
Bond It Mould Stop - Clear 1L 
Code 3 Cast Lead - 914mm x 6m 
Timloc Plastic Insulation Retaining Discs - 80mm Red 
The Eaves Vent Roll Out Rafter Tray by Timloc is an outstanding product that enables ventilation to your roofing system, combating condensation and aiding the structural integrity of the building. It has been quality tested against various regulations and standards, and it has passed the following;
- All NHBC Requirements
- BS EN ISO 9001
- BS EN ISO 14001
- All Building Standards
- All relevant Building Regulations
Installation
Unroll the ventilator along the rafters, and this should be along the entire length of the eaves on both sides of the building, creating a cross-flow ventilation action.
Position centrally above the wall plates because it's the narrowest part of the roof and is most likely to constrict the airflow of the roof insulation.
Push the corrugations down over the top of the rafters and secure them using clout nails or staples.
