Timco Grouting Float 
Soudal Trade Gun and Foam Cleaner - 500ml 
FrogTape® Multi-Surface Masking Tape - Green 36mm x 41.1m 
Cromar Acrypol+ Plus Roof Coating Waterproof System - Grey 2.5kg 
OX Tools OXIT Sealant & Adhesive - White 290ml (Box of 12) 
Cromar Bitumen Primer – Black 1 Litre 
Bora Workhorse XT Adjustable Height Single Piece Stand 
Soudal Insulating Foam Genius Gun 750ml - Champagne 
Ronseal Crystal Clear Outdoor Varnish - Matt 2.5L 
Everbuild P14 System Inhibitor – 1 Litre 
OX Pro Brick Hammer - 24 oz 
ALM Code 6 Milled Lead Flashing - 850mm x 3m 
Everbuild Quick Drying Clear Varnish - Gloss 250ml 
Code 5 Cast Lead - 850mm x 6m 
Everbuild Feb® Rendamix - 5L Amber 
Bond It Bitumen Primer - Black 5L 
Everbuild Salt-Away Salt Remover – 5 Litre 
Soudal B1 Fire Class Expanding Foam Handheld - 750ml 
Easy-Trim Over Fascia Vent - 10mm x 1m 
OX Pro Tuff Rule - Cyan 
Sika Stone Protector - Clear 5 Litre 
Hedgehog Gutter Brush Leaf Guard Black - 4m x 200mm 
Timco FirmaHold Collated ST Brad Nails A2 SS - 18g x 5000 PCS 
Everbuild P45 Foam Applicator Gun 
Bond It Mega Stik PU Adhesive - Beige 750ml is a fast-curing adhesive foam. Designed specifically to aid in the installation of plasterboard, insulation boards, floorboards and roof decking.
It adheres well to most commonly used building materials: plaster, wood, metals, bituminous membranes and mineral wool and can even be used in place of backing rods in expansion joints and around window and door frames.
Preparation
Ensure to cover all surrounding surfaces with paper or plastic sheets to protect them from any drips of foam.
- The foam needs moisture to begin the curing process, mist the substrate with water prior to application
Application
When applying this product, make sure to wear gloves and eye protection at all times.
- If needed, warm the cans in some lukewarm water (not above 50°C) and shake for at least 30 seconds before fixing to the foam gun.
- Apply the beads to the substrate and leave for approx . 2 minutes before pressing into place. Hold board in place for around 1 minute until adhesive has began to cure.
- You should apply the boards in rows, starting from the bottom of the wall and working up to the top to avoid sliding.
Plastering can be done after 1 hour of application.
Limitations
- Cured foam is sensitive to direct sunlight and UV light so should be covered with an opaque sealant, filler, paint or other suitable material.
- Not recommended for use on polyethylene, silicone, oil and grease
