OX Pro Dry Wall External Corner Trowel - 100mm x 125mm 
Code 7 Cast Lead - 240mm x 3m 
ALM Code 5 Milled Lead - 1600mm x 6m 
Code 4 Cast Lead - 914mm x 3m 
OX Pro Chalk Refill, White – 226g 
Code 3 Cast Lead - 600mm x 3m 
OX Pro Grout Remover 
OX Trade Plastic Speed Rafters Square Set 
Everbuild Forever Clear Silicone Sealant – 295ml (Box of 12) 
ALM Code 8 Milled Lead - 390mm x 6m 
Thompson's Emergency Roof Repair Mastic - Black 750ml 
Freeflow 112mm Round Gutter System 90° Gutter Angle - Black 
Hambleside Danelaw Double Roman Tile Vent, TV15/3 - Black (Box of 5) 
Everbuild Mitre Fast Activator – 200ml (Box of 12) 
Gorilla Tape - Black (48mm x 32m) 
ALM Code 6 Milled Lead Flashing - 1000mm x 3m 
Soudal Neutral Stay Fresh Sanitary Silicone Sealant – Clear 300ml (Box of 12) 
Soudal Soudafoam Hand Held One Shot - 150ml (Box of 12) 
Soudal Pro 30D Waterproof Wood Adhesive - 750g 
Soudal Roof & Gutter Sealant – Black 290ml (Box of 12) 
Hambleside Danelaw (HD DPCSPA) Tile Vent Adaptor and Flexi for TV10 Range 
IKO Super Shed Felt - Green 8m Roll 
Everbuild Safer Spirit - 750ml 
OX Polyzip™ Flex C1 Cutter - 15mm to 28mm 
Easy-Trim Hall Clips, Bag of 50 
Everbuild Bath & Kitchen Sealant – White 290ml 
Uses
The Everbuild Stick2 Carpet Fix Spray is a high-quality adhesive spray with a high tack, making it perfect for bonding carpets and various other substrates. Everbuild delivers this product in a spray can, allowing easy and faster application. Suitable for not only bonding carpets but multiple other surfaces, including;
- Polyurethane
- Foam back carpets
- Carpet tiles
- Underlay
- Paper felt
- Cork
- Rubber
- Metal
- Leather
- Most plastics
Preparation
It's essential to prepare the surface before application to achieve optimal results. First, clean the surface by removing contaminants that can hinder the adhesion, including dirt, dust, oil, grease, etc. Leaving all substrates bonded in a warm area to heat up slightly is recommended, preventing longer curing times and glue lines.
Application
- Shake the can thoroughly before using it.
- You can adjust the nozzle to change the width of the spray to your desire
- Apply to both surfaces from about 15-20 cm away, then bring together.
- For a stronger bond, you can coat the substrates three times in one application and allow the solvents to evaporate, which takes 30 seconds, then bring the surfaces together.
Limitations
- This product is not suitable for fixing vinyl floor tiles
- Do not apply to polystyrene
- This should not be applied to cellulose-painted surfaces
- Do not apply to surfaces that leak bitumen or tar
