OX Pro Aluminium Hawk - 13 inch x 13 inch 
ALM Code 7 Milled Lead - 390mm x 3m 
Everbuild Tecnic Silicone 825 – Magnolia 380ml (Box of 25) 
ALM Code 8 Milled Lead - 390mm x 6m 
Hedgehog Gutterbrush Clips (Pack of 20) 
Easy-Trim Universal Dry Verge System - Brown (Box of 50) 
Everbuild Pro Blue Masking Tape - 25mm x 33mm 
Hambleside Danelaw TV15/1 Flush Fitting Tile Vent - Brown (Box of 5) 
Siroflex Trade High Viscosity Superglue - 50g 
Bostik Flexacryl Instant Repair Waterproofing - Grey 5kg 
Bond It Mould Stop - Clear 5L 
Ulti-Mate Bold Roll Brown Tile Vent 
Leadax Lead Free Flashing Alternative 600mm (6M Rolls) 
Ronseal Big Hole Smooth Finish Filler - Grey 1.2Kg 
OX Pro OX-P133855 Easy Start Handsaw 550mm / 22in 
Timco Ratcheting Screwdriver 46-Part Set 
Everbuild Triple Action Wood Treatment – 2.5 Litre 
Isoflex Liquid Rubber - 4.5L 
Code 5 Cast Lead - 914mm x 3m 
Bond It PVA & Adhesive Sealer White 1L - Box of 12 
Ronseal Ultra Tough Hardglaze Clear Varnish - 250ml 
Klober Profile-Line Limarech Tile Vent - Antique Red KG9859-3-0116 (Box of 10) 
Uses
The Everbuild Stick2 Carpet Fix Spray is a high-quality adhesive spray with a high tack, making it perfect for bonding carpets and various other substrates. Everbuild delivers this product in a spray can, allowing easy and faster application. Suitable for not only bonding carpets but multiple other surfaces, including;
- Polyurethane
- Foam back carpets
- Carpet tiles
- Underlay
- Paper felt
- Cork
- Rubber
- Metal
- Leather
- Most plastics
Preparation
It's essential to prepare the surface before application to achieve optimal results. First, clean the surface by removing contaminants that can hinder the adhesion, including dirt, dust, oil, grease, etc. Leaving all substrates bonded in a warm area to heat up slightly is recommended, preventing longer curing times and glue lines.
Application
- Shake the can thoroughly before using it.
- You can adjust the nozzle to change the width of the spray to your desire
- Apply to both surfaces from about 15-20 cm away, then bring together.
- For a stronger bond, you can coat the substrates three times in one application and allow the solvents to evaporate, which takes 30 seconds, then bring the surfaces together.
Limitations
- This product is not suitable for fixing vinyl floor tiles
- Do not apply to polystyrene
- This should not be applied to cellulose-painted surfaces
- Do not apply to surfaces that leak bitumen or tar
