FloPlast Half Round Internal Stop End, White – 112mm 
Code 8 Cast Lead - 150mm x 6m 
Ronseal 3 in 1 Basecoat - White 2.5L 
Soudal Pro 30D Waterproof Wood Adhesive - 750g 
Ronseal Stays White Ultra Tough White Satin Paint - 750ml 
Everbuild Everflex AquaMate Aquarium Sealant – Translucent 295ml (Box of 12) 
OX Heavy Duty Soft Gel Filled Knee Pad 
Timco Lithium EP2 Grease - 400g 
Freeflow Square Gutter System Internal Stopend - White 
Hambleside Danelaw Double Roman Tile Vent, TV15/3 - Slate Grey (Box of 5) 
Cromar Vent 3 Light Breathable Membrane - 1m x 25m 
ALM Code 7 Milled Lead - 800mm x 6m 
FloPlast Half Round Fascia Bracket, White – 112mm 
Everbuild Mitre Fast Industrial Kit Superglue (Box of 24) 
Colron Refined Finishing Wax - 325g 
Everbuild Industrial Superglue HV – Clear 20g 
ALM Code 8 Milled Lead - 210mm x 3m 
Ronseal Knot Block Primer & Undercoat - White 2.5L 
Everbuild Gun A Nail Standard – White 310ml 
ALM Code 4 Milled Lead - 1200mm x 3m 
Code 4 Cast Lead - 1200mm x 3m 
Ronseal Exterior Yacht Varnish - Gloss 1L 
Everbuild External Frame Sealant - Stone 290ml (Box of 12) 
Uses
The Wood Pro Adhesive by Bond It unique hybrid formula is perfect for bonding various types of wood as well as different porous and non-porous substrates, ideal for sealing the wood to the floor; some of the surfaces you can apply it include;
- Parquet
- Mosaic
- Oak
- Wood Block
- Laminate
- Exotic timber
- Chipboard
- Plywood
- Concrete
- Anhydrite
Preparation
Before an application can begin, prepare the surfaces by removing any contaminants interrupting the adhesion, including grease, polish, dust, old adhesive remnants and similar impurities. Any damage to the surface, for example, cracks, should have remedial work done to it before covering it with adhesive and wood. Suppose you intend to have heated wood flooring. In that case, you'll need to ensure that you've turned it off 48 hours before the application and turn it back on 48 hours after application completion.
Application
- Apply using a standard sealant gun.
- Cut the top of the cartridge without damaging the threaded screw.
- Screw the nozzle onto the top of the cartridge.
- Apply in a wave motion, making the width around 8mm wide and the height 10mm high between each wave. It will ensure equal coverage across the wood.
- Place the wood with a slight twisting motion and tap into place to tightly secure the two surfaces.
Limitations
Do not apply this product below 10°C and above 30°C; materials should be acclimatised to this temperature in the intended application site prior to installation.
