Everbuild Jumbo Mitre Fast Kit (Box of 6) 
OX Pro Electricians Chisel - 2¼" X 10" 
OX Pro Chalk Refill, Yellow – 226g 
OX Pro Heavy Duty Aviation Snips Left Cut (Red) 
Everbuild 5 Minute Polyurethane Wood Adhesive Gel - 310ml (Box of 12) 
Siroflex Trade High Viscosity Superglue - 20g 
Everbuild Multi-Stick Adhesive - White 350ml 
ALM Code 6 Milled Lead Flashing - 180mm x 3m 
Cromar Alphachem Liquid Mortar Tone - Black 5L 
Klober Double Pantile Vent - Brown KG9858-3-0247 (Box of 10) 
Everbuild Stick2 Spray Contact Adhesive – Beige 500ml 
OB41 White Grease Spray - 400ml 
Code 6 Cast Lead - 600mm x 6m 
Code 5 Cast Lead - 210mm x 3m 
Hambleside Danelaw TV15/7 Tile Vent - Black (Box of 5) 
OX Pro 4 In 1 Heavy Duty Staple Gun 
Freeflow 112mm Round Gutter System Stopend Outlet - White 
ALM Code 3 Milled Lead - 510mm x 6m 
Ronseal Stays White Ultra Tough White Matt Paint - 2.5L 
Everbuild Mitre Fast Activator – 200ml 
How to Use
Fit the metal stand onto the front of the gun in the slots by the nozzle. Load a Bostik Handy Hot Melt Glue Stick through the grip ring at the rear of the gun. Press the trigger several times until the stick is firmly embedded in the gun. Plugin the gun and a light will come on at the rear to indicate that it is in operation. Rest the gun on its stand and allow it to warm up for approximately 5 minutes. Ensure surfaces to be bonded are clean and dry. Press trigger until adhesive flows from the nozzle. To ensure a continuous flow of glue, insert further glue sticks into the rear of the gun and wait a few minutes until the stick has heated to the correct temperature. Apply adhesive to one surface. Press surfaces together within 15 seconds. Use of a clamp or other holding device is not necessary.
Unplug the gun when finished and allow it to cool before storing. Surplus glue stick may be trimmed off using a sharp knife. Do not pull glue sticks from the back of the gun as damage may occur.
