Everbuild Black Jack 904 Roof Felt Adhesive – 5 Litre 
ALM Code 4 Milled Lead - 300mm x 3m 
ALM Code 6 Milled Lead Flashing - 914mm x 3m 
ALM Code 3 Milled Lead - 390mm x 6m 
Code 4 Cast Lead - 210mm x 3m 
Code 5 Cast Lead – 650mm x 6m 
Ronseal Exterior Multi-Purpose Smooth Finish Filler - Grey 1.2Kg 
Timco Assorted Horseshoe Shims - 1.0 to 6.0mm (Box of 200) 
Bostik Brushable Waterproofer - Black 5L 
Code 6 Cast Lead - 150mm x 3m 
Timco Lifting Sling 3000kg Limit - 2m x 90mm 
Everbuild 403 Concrete Hardener & Dustproofer – 5 Litre 
Restec CSM Fibreglass Roll 450g/m² - (15m² Roll) 
Code 7 Cast Lead - 760mm x 3m 
Code 8 Cast Lead - 300mm x 3m 
Timco Mixed Cable Clips 
Everbuild Black Jack 904 Roof Felt Adhesive – 2.5 Litre 
OX Pro OX-P133855 Easy Start Handsaw 550mm / 22in 
Everbuild Stick2 Spray Contact Adhesive – Beige 500ml 
Uses
Stick2 Rapid Epoxy Syringe is an exceptionally strong bonding two-part system that cures to a strength that can be drilled, sanded or painted. This product offers what most other adhesives don't, a glue capable of bonding almost any surface to another. It can be used for bonding;
- Metals
- Glass
- Wood
- China
- Dry Concrete
- Fabrics
- Rubber
- Crystals
- Jewellery
- Precious Stones
- Various Hard Plastics
Preparation
Prepare the surface before applying, and remove any contaminants hindering the adhesion. This includes; dust, oil, grease, general dirt and similar impurities. You can roughen the surface with sandpaper, and this optimises adhesion.
Application
- Remove the cap from the top of the product and snap off the tab from the bottom of the nozzles.
- Use the plunger to extrude equal lengths of resin and hardener onto a clean surface and place the cap back onto the product.
- Mix thoroughly for 30 seconds to 1 minute using the stick provided.
- Once mixed, use it within 4 minutes, applying small quantities at a time and immediately bringing both surfaces together.
- Hold surfaces together firmly, and if needed, use clamps to support the curing process, which will take 10 minutes at 20°C
Limitations
- This product is unsuitable for repairing areas containing food or drink.
- Ensure you do not cross-contaminate the hardener with the resin, as it causes the tubes to cure inside.
