Sika Damp-Proof Slurry Grey - 25kg 
Everbuild Smart Tack Handy – 500ml (Box of 12) 
Timco Precision Screwdriver Set 6pcs 
Easy-Trim Over Fascia Vent - 25mm x 500mm (Box of 50) 
Timco Ratcheting Screwdriver 46-Part Set 
FloPlast Black Half Round Adjustable Angle - 50° to 156° 
Freeflow 112mm Round Gutter System 90° Gutter Angle - Black 
Code 4 Cast Lead - 1600mm x 6m 
Everbuild Ultra Hard Floor Varnish – Clear 2.5 Litre (Gloss) 
Code 3 Cast Lead - 180mm x 6m 
Code 5 Cast Lead - 180mm x 3m 
Restec Flexitec 2020 Roofing Kit - (10m²) 
Cast Lead Dome Set (Lead Dots) - Pack of 20 
FloPlast Half Round Union Unit - White 
Code 8 Cast Lead - 450mm x 3m 
Siroflex SX Contractors LMN Silicone OAK 300ml 
Bond It Rubber Bitumen Emulsion - Black 5L 
OX Tools OXIT Sealant & Adhesive - Clear 290ml (Box of 12) 
ALM Code 7 Milled Lead - 914mm x 3m 
YBS SuperQuilt Lite Multi-Layer Quilted Foil Insulation, 1.5m x 10m 
Everbuild Lumberjack 5 Minute Wood Adhesive Deal 
Everbuild Lumberjack® Woodworm Killer - Clear 5L 
ALM Code 3 Milled Lead - 850mm x 6m 
Bond It Mould Stop - Clear 2.5L 
Uses
Stain Block Damp Seal by Thompson's delivers excellent properties, restoring walls and ceilings to their original glory. Thompson's Scientist brewed this product with a low odour, solvent-based, highly pigmented acrylic system, allowing a consistent and effective restoration.
Preparation
Ensure that before you begin the application, you remove the source of dampness. Additionally, remove any wallpaper and flaking paint with a damp cloth, and any cracks or holes should be filled. Open all doors and windows to make a well-ventilated room, and note that you can apply this product to a damp surface, not a dripping wet one.
Application
- Give the tin a thorough stir
- Using a brush or roller
- Dip it into the paint and apply directly to the affected area, plus 30cm around it.
- After 2 hours, the first coat will dry. However, don't apply the second coat or decorate on top until 4 hours after.
Limitations
- Do not apply this product if the air or surface temperature it below 10°C.
- This product isn't suitable for external surfaces, below ground level or where efflorescence is present.
- Before commencing treatment, ensure you prevent all causes of dampness, including structural and plumbing faults and rising dampness.
