Bond It Economy Sealant Gun - Blue 900ml 
ALM Code 8 Milled Lead - 450mm x 3m 
Code 4 Cast Lead - 360mm x 6m 
Code 3 Cast Lead - 1200mm x 3m 
Bond It Rubber Bitumen Emulsion - Black 5L 
ALM Code 6 Milled Lead Flashing - 300mm x 6m 
Everbuild Lumberjack 550 Floor Adhesive – 600ml 
Timco Copper Slate Straps 
Timco FirmaHold Collated ST Brad Nails A2 SS - 18g x 5000 PCS 
Everbuild Black Jack 901 Black Bitumen Paint – 5 Litre 
Armatool Stripping Spade 
Cromar Roof Felt Adhesive - Black 1 Litre 
Code 6 Cast Lead - 300mm x 3m 
Bond It Mega Stik PU Adhesive - Beige 750ml 
Thompson's Patio & Block Paving Anti-Slip Additive - 200g 
Preparation
Prepare the surfaces before application, and remove any contaminants that are present, this includes dust, oil and grease. Suppose the application area has imperfections on the surface, for example, cracks or holes. In that case, you must repair this before applying the coat.
Application
- Ensure the area of application is well-ventilated. Shake the can until the mixing ball rattles back and forth for at least 1-2 minutes.
- Spray directly onto the surface, applying the coat evenly, holding the can about 20-30cm away from the surface.
- Apply 2-3 coats depending on the stain; give around 15 minutes between each coat.
- Depending on the environment and porosity of the surface will affect the drying time. Despite that, it takes about 2 hours on average for the surface to be prepared for decoration.
Limitations
You should not apply this product whilst the temperature is below 10°C or on a surface with an RH reading of 90% or above.
Coverage
One 400ml can cover 0.75m² dependent on the porosity of the surface.
