Everbuild Stixall Extreme Power - Brown 290ml (Box of 12) 
Bond It Stabilizing Solution - White 5L 
Timco Flat Wood Bit Set 
Soudal Mitre Kit 50g + 200ml - Clear 
Timco FirmaHold Collated Brad A2 Stainless Steel Nails - 16G x 50mm (2000 Pieces) 
Timco Velocity Premium Multi-Use Screws - Mixed Tray 
Hedgehog Gutter Brush Leaf Guard Black – 4m x 125mm 
Soudal Grab Solvent Based Adhesive, Beige 
ALM Code 4 Milled Lead - 450mm x 3m 
Sika Dustproofer – Clear 5 Litre 
Bond It Mirror Pro Adhesive - White EU3 
Everbuild Anchorset Green 300 - Grey 300ml 
Timco Lithium EP2 Grease - 400g 
Timco Nut Mix Grab Pack - 980 Pieces 
ALM Code 3 Milled Lead - 510mm x 3m 
Timloc Castellated Tile Vent Grey (Box of 8) 
Klober Small Slate Vent - Slate Grey 
Everbuild 402 Waterseal – 25 Litre 
FloPlast Half Round Internal Stop End, Black – 112mm 
Klober Profile-Line Twin Plain Tile Vent - Brown KG9861-0247 (Box of 10) 
Everbuild 709 FebFlor Floor-Flex Plus - 5 Litre 
Right Hand Klober Contract Dry Verge Unit Brown 
Freeflow 112mm Gutter Internal Stop End - Black 
Bond It Gripbond Pro Max Adhesive - White EU3 
Bond It Mould Stop - Clear 5L 
This Bond It Silicone Ultra Waterseal delivers impressive results preventing the ingress of rain and moisture into the wall, however, it does enable present water in the stone to evaporate from it, allowing your walls to be drier, warmer and help prevent future damages.
The uses of this product include being a general masonry waterproofer, suitable for application on brick, stone, concrete and unglazed tiles. Not only is water deflected and protected against, but also frost damage so that those cold winter months will have less of a toll on your building.
Application
Prepare all surfaces before application, this includes removing dirt, moss, lichen and any other organic growth that is present. If you find it challenging to remove particular organic growth, consider using Bond Its MOULD-STOP or PATIO-BLASTER as these are effective at eliminating these. If any fresh pointing is present, allow 24 hours for it to dry. All surfaces must be clean and dry before you start the application.
Do not use this product during rainfall, if rainfall is imminent, ensure you protect the are so it can cure properly. Do not apply this product on painted surfaces, however you can paint onto the surface after applying this product using breathable paints.
- Shake well before use.
- Apply using a low-pressure spray that isn't atomizing, or brush at a rate of 3m² per litre for porous stone and 5m² per litre for hard brick. Starting from the top and working your way down, making sure the surface is wetted well
- A second coat is required and should be applied when the masonry is still wet/tacky
