Everbuild Stixall Extreme Power – Grey 290ml 
Thompson's One Coat Waterseal - 1L 
Everbuild Everflex AquaMate Aquarium Sealant – Translucent 295ml (Box of 12) 
Soudal Swipex Wipes - 100 Wipes 
Everbuild Plumbers PVC Pipe Cement - Clear 250ml (Box of 12) 
FloPlast Black Half Round Adjustable Angle - 50° to 156° 
Code 5 Cast Lead - 800mm x 6m 
Timloc 1204 Underfloor Vent Vertical Extension + 150mm 
ALM Code 5 Milled Lead - 1200mm x 6m 
Sika Mould Buster – 5 Litre 
Easy Prime Porcelain Prime Slurry - 15kg 
Everbuild Anchorset Green 150 - Grey 150ml 
Timco Extra Heavy Duty Hand Cleaner with Pump - 4 Litres 
Everbuild Caulk Once – White 380ml (Box of 12) 
Ronseal Crystal Clear Outdoor Varnish - Satin 2.5L 
Bond It Rubber Bitumen Emulsion - Black 5L 
Pinkgrip Dryfix Applicator Gun 
Ronseal One Coat Stays White Radiator Paint - Gloss 750ml 
Timloc Dry Fix Roll Out Ridge System Pack - Black 6m 
FloPlast Square Line Pipe Connector Black 
Soudal Repair Express Plaster - White 250ml 
Everbuild P13 Plumbers Putty - Beige 750g 
20 Boxes x Extra Large Head Clout Nails, Galvanised 
Everbuild Roof & Gutter Sealant - Black 295ml (Box of 12) 
IKO Shed Felt - Green 10m Roll 
Thompson's Water Seal - 1L 
This Bond It Silicone Ultra Waterseal delivers impressive results preventing the ingress of rain and moisture into the wall, however, it does enable present water in the stone to evaporate from it, allowing your walls to be drier, warmer and help prevent future damages.
The uses of this product include being a general masonry waterproofer, suitable for application on brick, stone, concrete and unglazed tiles. Not only is water deflected and protected against, but also frost damage so that those cold winter months will have less of a toll on your building.
Application
Prepare all surfaces before application, this includes removing dirt, moss, lichen and any other organic growth that is present. If you find it challenging to remove particular organic growth, consider using Bond Its MOULD-STOP or PATIO-BLASTER as these are effective at eliminating these. If any fresh pointing is present, allow 24 hours for it to dry. All surfaces must be clean and dry before you start the application.
Do not use this product during rainfall, if rainfall is imminent, ensure you protect the are so it can cure properly. Do not apply this product on painted surfaces, however you can paint onto the surface after applying this product using breathable paints.
- Shake well before use.
- Apply using a low-pressure spray that isn't atomizing, or brush at a rate of 3m² per litre for porous stone and 5m² per litre for hard brick. Starting from the top and working your way down, making sure the surface is wetted well
- A second coat is required and should be applied when the masonry is still wet/tacky
