Timco Skeleton Gun 
Klober Universal Tile Vent Terracotta KG9854 (Box of 10) 
Gorilla Glue - Dark Brown 60ml 
Hambleside Danelaw Double Pantile Vent TV15/2 - Brown (Box of 5) 
Bond It Contractors PVA - 25L White 
Bond It Patio Blaster - Clear 5L 
Stanley Dynagrip Chisel Knife - 25mm 
Soudal Repair Express Cement – Beige 290ml (Box of 12) 
Everbuild Seal Rite Strip / Smooth Out Twin Pack 
Everbuild Gun A Nail Standard – White 310ml 
Code 6 Cast Lead - 180mm x 6m 
Ronseal Stays White Ultra Tough White Gloss Paint - 750ML 
Everbuild 404 Fungicidal Wash – 1 Litre 
Siroflex Trade Clearbond Adhesive Internal Use - Clear 290ml 
Bond It Dustproof & Hardener - Clear 5L 
Ulti-Mate Plain Tile Vent Adaptor 
Easy-Trim Universal Dry Verge System - Grey 
ALM Code 6 Milled Lead Flashing - 240mm x 3m 
OX Pro Double Handle Pool Trowel 
Timco Flat Wood Bit 1/4" Extension Rod - 150mm 
OX Pro Top Steady Nail-On (Full Kit) Clamp Set 
Easy-Trim Lead R Flashing Textured – 150mm x 5m 
Everbuild Everflex 200 Contractors LMA Silicone - White 295ml 
Uses
Stick2 Rapid Epoxy Syringe is an exceptionally strong bonding two-part system that cures to a strength that can be drilled, sanded or painted. This product offers what most other adhesives don't, a glue capable of bonding almost any surface to another. It can be used for bonding;
- Metals
- Glass
- Wood
- China
- Dry Concrete
- Fabrics
- Rubber
- Crystals
- Jewellery
- Precious Stones
- Various Hard Plastics
Preparation
Prepare the surface before applying, and remove any contaminants hindering the adhesion. This includes; dust, oil, grease, general dirt and similar impurities. You can roughen the surface with sandpaper, and this optimises adhesion.
Application
- Remove the cap from the top of the product and snap off the tab from the bottom of the nozzles.
- Use the plunger to extrude equal lengths of resin and hardener onto a clean surface and place the cap back onto the product.
- Mix thoroughly for 30 seconds to 1 minute using the stick provided.
- Once mixed, use it within 4 minutes, applying small quantities at a time and immediately bringing both surfaces together.
- Hold surfaces together firmly, and if needed, use clamps to support the curing process, which will take 10 minutes at 20°C
Limitations
- This product is unsuitable for repairing areas containing food or drink.
- Ensure you do not cross-contaminate the hardener with the resin, as it causes the tubes to cure inside.
