Everbuild External Frame Sealant - Brown 290ml (Box of 12) 
OX Pro Impact Bit Set - 11 Piece 
Gorilla Heavy Duty Mounting Tape - Crystal Clear (25mm x 1.5m) 
Timloc Mini Castellated Tile Vent Brown (Box of 14) 
OX Pro Mini Round Point Shovel 
Armatool Flooring Kneepads 
FloPlast Half Round To Cast Iron Half Round Gutter Adaptor - Black 
Thompson's Emergency Roof Seal - Black 2.5L 
ALM Code 3 Milled Lead - 800mm x 3m 
Bond It Patio Seal Paving & Patio Sealer, Clear - 5L 
ALM Code 6 Milled Lead Flashing- 1000mm x 6m 
Klober Permo Ecovent - 1.1m x 50m 
Everbuild 501 PVA – 500ml 
FloPlast Half Round Union Unit - Black 
Timco Velocity Premium Multi-Use Screws - Mixed Tray 
Everbuild P18 Gas Leak Detector - 400ml (Box of 12) 
Code 7 Cast Lead - 760mm x 6m 
Everbuild Lumberjack 550 Floor Adhesive – 600ml 
Soudal Cleaner & Degreaser - 400ml 
OX Pro Top Steady Nail-On (Veneer) Clamp Set 
Stanley Dynagrip Chisel Knife - 25mm 
Timco Round Wire Nails, Pack of 40 
Everbuild Quick Drying Clear Varnish - Gloss 250ml 
Timloc 1203 Underfloor Vent Horizontal Front Extension + 115mm 
OX Pro Aluminium Metric Rafters Square - 300mm 
Code 5 Cast Lead - 760mm x 6m 
Everbuild ASBO Graffiti Remover - 400ml 
Bond It Cove-Mate Coving Adhesive - White EU3 
Soudal Neutral Stay Fresh Sanitary Silicone Sealant – White 300ml 
Code 3 Cast Lead - 914mm x 6m 
D4 Wood Adhesive – 1 Litre 
Uses
Impact Adhesive by Evo-Stik offers outstanding adhesive properties, with its ability to instantly grab onto a surface, this product immediately binds surfaces and takes only 24 hours to reach its full strength. Despite the instant grab from the product, there is still an open time for movement between 20 - 60 minutes, depending on the temperature. Most glues cannot bind more challenging surfaces, such as non-porous and metal substrates, but this product can achieve full-strength adhesion. Some of the surfaces that this product is suitable for include;
- Wood
- MDF
- Laminate
- Metal
- PVC
- Cork
- Leather
- Rubber
- Glass
- Mirror
- Stone
- Ceramics
Preparation
Surfaces should be prepared before commencing the application to ensure optimal adhesion is achieved. This includes removing contaminants that can hinder the adhesion, such as dirt, dust, oil, grease and similar impurities.
Application
- Using a standard spreader, spatula or paintbrush
- Apply a thin coat of adhesive onto one of the surface
- Bring the surfaces together, holding them firmly together for a few minutes to allow the bond to form
- Leave the surfaces bonded together for a total of 24 hours to enable optimal adhesion to be achieved
Limitations
- This product is unsuitable for application on polystyrene, cellulose paint, vinyl, polythene, polypropylene and rayon fabrics. Always test in a small, inconspicuous area before completing the project if you need more clarification.
