Everbuild Jumbo Mitre Fast Kit (Box of 6) 
ALM Code 7 Milled Lead - 180mm x 6m 
Permavent Easy Slate 500 - Pack of 20 
Everbuild Stixall Extreme Power - Grey 290ml (Box of 12) 
Easy-Trim End Cap Angled - Black (Box of 10) 
ALM Code 5 Milled Lead - 390mm x 6m 
Timloc Telescopic Underfloor Vent 5-7 Courses 
ALM Code 4 Milled Lead - 210mm x 3m 
Soudal Soudabond 265 Classic Spray - 500ml 
Code 8 Cast Lead - 510mm x 6m Flashing Tape
Best Sellers
-
FloPlast Square Line Stop End Outlet Black – 114mm x 65mm
£5.99 Incl VAT £4.99 Excl VAT Add to basket -
JCB Horton Hoodie Navy
From: £22.90 Incl VAT £19.09 Excl VAT Select options This product has multiple variants. The options may be chosen on the product page -
Code 3 Cast Lead – 240mm x 3m
£31.42 Incl VAT £26.18 Excl VAT Add to basket -
Buckbootz BAZ Safety Boot Black Leather
From: £58.99 Incl VAT £58.99 Excl VAT Select options This product has multiple variants. The options may be chosen on the product page -
Timloc Single Pantile Tile Vent
From: £24.99 Incl VAT £20.83 Excl VAT Select options This product has multiple variants. The options may be chosen on the product page -
Easy-Trim Universal Dry Verge System Black (Box of 50)
£77.40 Incl VAT £64.50 Excl VAT Add to basket
Flashing Tape
Roofing flashing tape, also known as flashband or lead flashing tape, is one of many ways to protect, repair, and watertight seal something permanently. Due to its heat resistance and ability to provide an immediate watertight seal on an enormous variety of surfaces, it is an essential part of any roofing project. In addition, it comes in multiple sizes to suit your roof needs.Â
Among our range, we have the excellent Cromar Flashing Tape, Bostik Flashing Tape and Everbuild’s flashing trade tape.
How To Apply Flashing Tape the Correct Way
To help out, here is a short guide on how to apply flashing tape.
Cut the Flashing Strip to the length required. To avoid any creasing, remove approximately 50mm of backing paper and carefully position the sealing strip. Hold the backing paper firmly and release it steadily from the sealing strip as the product is applied.
Smooth into position using hand pressure. Use a seam roller or rounded wood smooth to ensure good contact and expel any air, especially on overlaps and at the edges. When laying adjacent rolls, Flashing Strip should be overlapped by a minimum of 25mm for a watertight seal.Â
The seam must be pressed firmly with a hand roller paying particular attention at the point of overlap. Remember, if applying this in cold weather (5-15 Celsius), storing the flashing tape in a warm place is highly recommended before use. If possible, it is also suggested to warm up the surface slightly.
