Isoflex Clean Up Fluid - 500ml 
Bond It Patination Oil 500ml 
FloPlast Square Fascia Bracket White – 114mm 
Evo-Stik Liquid Nails Solvent Free - Buff 290ml 
Hambleside Danelaw TV10/6 Flush Fit Tile Vent - Brown (Box of 5) 
Spax Phillips Ph1 Drill Bits - 25mm (Pack of 5) 
Everbuild Wet Rot Wood Hardener – 250ml Flashing Tape
Best Sellers
-
OX Pro Impact Drill & Drive Accessory Set – 40 Piece
£34.99 Incl VAT £29.16 Excl VAT Add to basket -
Hambleside Danelaw Double Pantile Vent TV15/2 – Terracotta (Box of 5)
£114.99 Incl VAT £95.83 Excl VAT Add to basket -
Klober Single Pantile Vent – Brown KG9860-0247 (Box of 10)
£215.99 Incl VAT £179.99 Excl VAT Add to basket -
Samac Copper Clout Nails – 38mm x 3.35mm
From: £24.00 Incl VAT £20.00 Excl VAT Select options This product has multiple variants. The options may be chosen on the product page -
OX Pro Claw Bar
From: £15.89 Incl VAT £13.24 Excl VAT Select options This product has multiple variants. The options may be chosen on the product page -
Bond It Dec-Mate Flexible Filler – White EU4
£4.99 Incl VAT £4.16 Excl VAT Add to basket
Flashing Tape
Roofing flashing tape, also known as flashband or lead flashing tape, is one of many ways to protect, repair, and watertight seal something permanently. Due to its heat resistance and ability to provide an immediate watertight seal on an enormous variety of surfaces, it is an essential part of any roofing project. In addition, it comes in multiple sizes to suit your roof needs.
Among our range, we have the excellent Cromar Flashing Tape, Bostik Flashing Tape and Everbuild’s flashing trade tape.
How To Apply Flashing Tape the Correct Way
To help out, here is a short guide on how to apply flashing tape.
Cut the Flashing Strip to the length required. To avoid any creasing, remove approximately 50mm of backing paper and carefully position the sealing strip. Hold the backing paper firmly and release it steadily from the sealing strip as the product is applied.
Smooth into position using hand pressure. Use a seam roller or rounded wood smooth to ensure good contact and expel any air, especially on overlaps and at the edges. When laying adjacent rolls, Flashing Strip should be overlapped by a minimum of 25mm for a watertight seal.
The seam must be pressed firmly with a hand roller paying particular attention at the point of overlap. Remember, if applying this in cold weather (5-15 Celsius), storing the flashing tape in a warm place is highly recommended before use. If possible, it is also suggested to warm up the surface slightly.
