Armatool Leather Pouch & Leather Belt 
SikaGard Wood Preserver - Clear 5 Litre 
Klober Adaptor for 10K Slate and Profile-Line Vents - KG979100 
Soudal Trade Sanitary Silicone - White 290ml (Box of 12) 
ALM Code 6 Milled Lead Flashing - 150mm x 6m 
Code 4 Cast Lead - 850mm x 6m 
Timloc Dry Fix Roll Out Ridge System Pack - Black 6m 
Ronseal Fence Life Brush - 4" 
Everbuild Industrial Superglue HV – Clear 20g 
Bond It AS900 Acoustic Sealant - White 900ml 
Soudal Firecement HT, Black - 300ml 
Ronseal Precision Finish Brush - 1 Inch Angled 
Thompson's Patio & Block Paving Seal - Satin 5L 
Everbuild Dual Purpose Foam Cleaner – 500ml (Box of 12) 
Siroflex Trade Strength Medium Viscosity Superglue - 20g 
Ronseal Ultra Tough Mattcoat Clear Varnish - 2.5L 
ALM Code 4 Milled Lead - 1000mm x 6m 
Roughneck® Gorilla Bar Twin Pack - 35cm & 55cm (14in & 22in) 
Timco Polypropylene Rope - Blue 30m 
Klober Universal Vent 100mm Adaptor - KG968300-1 
ALM Code 5 Milled Lead - 450mm x 6m 
Klober Permo Ecovent - 1.1m x 50m 
Soudal Gun & Foam Cleaner Gun Grade - 500ml (Box of 12) 
ALM Code 8 Milled Lead - 150mm x 6m 
Sika MultiSeal Self Adhesive Bituminous Sealing Tape - (300mm x 10m) 
Uses
The All Weather Roofing Compound by Bond It is an excellent, general-purpose, high-performance, waterproofing compound that protects your roof from the environment. Its excellent formula allows it to resist water, drying into a tough, black coating. Its versatility is unmatched with it adhering to surfaces including;
- Asphalt
- Roofing Felt
- Corrugated Iron
- Fibre/Cement Slates
- Lead
- Copper
- Zinc
Preparation
Before commencing the application, you should ensure the surface is free from contaminants that can hinder the adhesion. Remove any dirt, dust, grease, oil, rust, and organic growth using a wire brush, fungicide, or rust inhibitor.
Application
- Stir the All Weather Roofing Compound thoroughly before using
- Apply to the surface via broom or brush
- Apply each coat at right angles to the previous one
- It should be applied to the surface at a maximum rate of 0.75 litres per m²
- Allow each coat to dry thoroughly before applying another; drying times can take up to 24 hours.
Limitation and Notes
- This product should not be used in areas subsequent to solvent contact
- Do not apply this product in potable drinking water tanks
- Ensure you allow sufficient drying time between coats.
- Bitumen naturally bleeds through paints, so a primer should be applied over the bitumen before painting.
