Ronseal Exterior Yacht Varnish - Satin 250ml 
Silweld Repair Tape, Black - 3m 
Everbuild Easi-Squeeze Flexible Decorators Filler - White 200ml 
ALM Code 7 Milled Lead - 600mm x 6m 
Code 5 Cast Lead - 800mm x 6m 
Bond It B2 Expanding PU Gun Grade Foam - Beige 750ml 
Bond It Bitumen Primer - Black 25L 
ALM Code 5 Milled Lead - 390mm x 6m 
Timloc Plain & Interlocking Tile Vent Adapter 
DeWalt XR Combi Drill & Impact Driver Twin Pack 
Soudal Swipex Wipes - 100 Wipes 
Everbuild Stick2 Carpet Fix Spray - 500ml 
OX Pro Small Trowel - 200 x 75mm 
Ronseal Precision Finish Brush - 1.5 Inch 
Lead Roofing Wood Core Roll (50mm x 2.4m) 
Bond It Cyanoacrylate Superglue Medium Viscosity, Clear - 50g 
SikaFlex EBT+ Polyurethane Adhesive & Sealant, Grey - 300ml (Box of 12) 
Everbuild Clear Fix – 290ml 
ALM Code 8 Milled Lead - 150mm x 6m 
FloPlast Square Fascia Bracket Black – 114mm 
Freeflow 114mm Round Gutter Drain Pipe Hopper - White 
Youngman Double Section Roof Ladder 3.77m (57663600) 
FloPlast Square Line Pipe Branch White – 65mm 
OX Tools OX Trade Hickory Handle Claw Hammer - 16oz/450g 
Bond It Aluminium Foil Tape - 75mm x 45M 
This Bond It Silicone Ultra Waterseal delivers impressive results preventing the ingress of rain and moisture into the wall, however, it does enable present water in the stone to evaporate from it, allowing your walls to be drier, warmer and help prevent future damages.
The uses of this product include being a general masonry waterproofer, suitable for application on brick, stone, concrete and unglazed tiles. Not only is water deflected and protected against, but also frost damage so that those cold winter months will have less of a toll on your building.
Application
Prepare all surfaces before application, this includes removing dirt, moss, lichen and any other organic growth that is present. If you find it challenging to remove particular organic growth, consider using Bond Its MOULD-STOP or PATIO-BLASTER as these are effective at eliminating these. If any fresh pointing is present, allow 24 hours for it to dry. All surfaces must be clean and dry before you start the application.
Do not use this product during rainfall, if rainfall is imminent, ensure you protect the are so it can cure properly. Do not apply this product on painted surfaces, however you can paint onto the surface after applying this product using breathable paints.
- Shake well before use.
- Apply using a low-pressure spray that isn't atomizing, or brush at a rate of 3m² per litre for porous stone and 5m² per litre for hard brick. Starting from the top and working your way down, making sure the surface is wetted well
- A second coat is required and should be applied when the masonry is still wet/tacky
