Ronseal One Coat Wood Primer & Undercoat - White 750ml 
Evo-Stik Gripfill Gap Filling Adhesive – 350ml 
Klober Boll Roll Tile Vent KG6085, Brown 
Spax Magnetic Bit Holder - 1 Piece 
Kwik Flash Lead Tool - Turn In Setting Tool For Lead & Zinc Flashing 
Bond It Organic Cleaner - Clear 2.5L 
Everbuild Lead Mate Patination Oil – 500ml 
Everbuild General Purpose Silicone - Black 290ml (Box of 12) 
Everbuild Pinkgrip Adhesive Solvent Based – 350ml 
Bond It Contractors Grade PVA - White 500ml 
ALM Code 8 Milled Lead - 360mm x 3m 
Ronseal Crystal Clear Outdoor Varnish - Matt 250ml 
Hambleside Danelaw TV15/1 Flush Fitting Tile Vent - Black (Box of 5) 
Roughneck® Gorilla Bar Twin Pack - 35cm & 55cm (14in & 22in) 
Bond It Heavy Duty Gun Foam Applicator 
Hambleside Danelaw (HD DPCSPA) Tile Vent Adaptor and Flexi for TV10 Range 
Code 5 Cast Lead - 914mm x 3m 
Bond It Rubber Bitumen Emulsion - Black 2.5L 
OX Pro Heavy Duty Aviation Snips Left Cut (Red) 
Soudal Cleaner & Degreaser - 400ml 
Timco Assorted Horseshoe Shims - 1.0 to 6.0mm (Box of 400) 
Everbuild Lumberjack 5 Minute PU Wood Adhesive Gel – 310ml 
FloPlast Half Round Gutter 90° Bend, Brown – 112mm 
SikaBond MS Wood Floor Gun Grade - Parquet Brown 600ml 
Uses
KOS Fire Cement by Everbuild is an excellent product that resists high temperatures. It comes in a ready-mixed blend of thermo-setting resins and temperature-resistant inorganic fillers that cures when exposed to heat to give a seal that is resistant to heat.
Preparation
The surfaces must be prepared, remove any dust, oil, grease or other contaminants present, and wet all surfaces to give a good key.
Application
- Use the product straight from the tub; soften it with water slightly if needed.
- Use a trowel and apply well into the area, filling and covering the surface.
- After the first application, increase the heat of the cement gradually over 4 hours. A crack may start to form; if so, re-apply the cement to the area, this will create a smoke-tight seal.
Limitations
- This product is not suitable as a gas sealant
- Always moisten the surface before applying
- Always apply heat gradually
- The Black will turn into a buff/grey colour above 650°C
- Not suitable for use where the product is exposed to water
