Code 7 Cast Lead - 800mm x 3m 
OX Pro Tough Nylon Braided Builders Line 105m / 350ft - Cyan 
OB41 Fast Tack Contact Adhesive Spray - 500ml 
ALM Code 7 Milled Lead - 1000mm x 3m 
OX Tools 12 inch / 300mm Pro Stainless Steel Plasterers Mud Pan 
Lead Hall Fixing Clips - Pack of 50 
Everbuild Black Jack 901 Black Bitumen Paint – 25 Litre 
Bond It Rubber Bitumen Emulsion - Black 2.5L 
Timloc 1205 Underfloor Vent Horizontal Duct Adapter - 110mm 
Timco Lithium EP2 Grease - 400g 
ALM Code 4 Milled Lead - 1000mm x 3m 
Ronseal Stays White 2in1 Paint & Primer - Gloss 750ml 
Bond It Mould Stop - Clear 5L 
ALM Code 6 Milled Lead Flashing - 390mm x 6m 
Thompson's One Coat Damp Seal - White 750ml 
ALM Code 8 Milled Lead - 850mm x 3m 
Everbuild 701 Non-Slip Tile Adhesive – White 3.75kg 
Uses
KOS Fire Cement by Everbuild is an excellent product that resists high temperatures. It comes in a ready-mixed blend of thermo-setting resins and temperature-resistant inorganic fillers that cures when exposed to heat to give a seal that is resistant to heat.
Preparation
The surfaces must be prepared, remove any dust, oil, grease or other contaminants present, and wet all surfaces to give a good key.
Application
- Use the product straight from the tub; soften it with water slightly if needed.
- Use a trowel and apply well into the area, filling and covering the surface.
- After the first application, increase the heat of the cement gradually over 4 hours. A crack may start to form; if so, re-apply the cement to the area, this will create a smoke-tight seal.
Limitations
- This product is not suitable as a gas sealant
- Always moisten the surface before applying
- Always apply heat gradually
- The Black will turn into a buff/grey colour above 650°C
- Not suitable for use where the product is exposed to water
