Hambleside Danelaw (HD PCSPA) Tile Vent Adaptor and Flexi for TV10 Range 
Samac Half Round Snowguard Bracket - 150mm (6") 
Thompson's Emergency Roof Seal - Black 2.5L 
Bond It Cyanoacrylate Superglue Medium Viscosity, Clear - 20g 
Everbuild Opti-Mix Mortar Plasticiser - 1 Litre (Box of 12) 
Everbuild KOS Fire Cement Buff – 2kg 
Soudafoam Gap Filler Gun Grade – 750ml (Box of 12) 
Code 7 Cast Lead - 1600mm x 6m 
Ronseal Quick Drying Radiator Spray Paint - White Satin 400ml 
Chesterfelt Shed Roofing Felt - Green Standard 10m 
OX Pro Heavy Duty Aviation Snips Left Cut (Red) 
OX Tools 600/1200/1800mm Pro Spirit Level Set with Bag 
Code 8 Cast Lead - 760mm x 6m 
FloPlast Square Line Downpipe Clip White 
ALM Code 7 Milled Lead - 510mm x 3m 
ALM Code 6 Milled Lead Flashing - 760mm x 3m 
Soudal B2 Fire & Acoustic Expanding Foam – 750ml (Box of 12) 
Timco Grouting Float 
Timco Driver and Ground Jobber Bit Set 
OX Tools Pro Torpedo Level, 9" / 230mm 
Everbuild External Frame Sealant - Brown 290ml (Box of 12) 
Thompson's Emergency Roof Repair Mastic - Black 750ml 
Klober 15x9 Tile Vent - Terracotta KG9690-0152 (Box of 10) 
Bond It Power Frost Premium Quality Concentrate Additive - 1L Pale Blue 
Everbuild Filler Coat – White 5 Litre 
Uses
Stick2 Hard Plastic Adhesive by Everbuild is excellent at adhering to various types of plastics and synthetics together. It attaches to surfaces such as;
- PVC
- Acrylic
- Polycarbonate
- Abs
- Rigid PVC
These are just a few distinctive surfaces that it can adhere to; the typical application found with this product includes;
- PVC Guttering Repairs
- General PVC Bonding
- ABS non-pressure pipework
- General repairs to;
- Hairdryers
- Refrigerator doors
- Irons
- Vacuum cleaners
- Plastic toys
- Record Players
- AV Equipment
Preparation
Ensure that you properly prepare the surface before starting the application, and remove any present contaminants like dust and dirt which can hinder this product's adhesion.
Application
Always use this product over a protected surface, and use this product in a well-ventilated area.
- Remove the cap and pierce the inner membrane, apply a thin, even layer of adhesive to both surfaces and assemble immediately.
- Reposition either surface within the first 10 minutes of application,
Full strength is achieved after 24 hours at a temperature of 20°C. After you finish your application, screw the cap back on top.
Limitations
- This product will not stick polyethene, polypropylene, polystyrene, PTFE, nylon or bakelite
- This product should not be used near polish or certain painted surfaces
- This product is not suitable for areas in constant water immersion
- Do not use this product on bitumen, asphalt, or cellulose-panted surfaces
- Do not use it as a mirror adhesive, as this product may attack the mirror backing
- Do not use this product below 5°C
