Everbuild Lumberjack Wood Preserver – Clear 1 Litre 
Code 3 Cast Lead - 300mm x 3m 
FloPlast Half Round Fascia Bracket, White – 112mm 
OX Tools Winter Set - Beanie, Socks, Thermal Gloves 
Bond It Multi-Purpose Low Viscosity Spray Lubricant - 400ml Clear 
ALM Code 3 Milled Lead - 240mm x 6m 
Timloc Interlocking Plain Tile Vent Red (Box of 12) 
Everflex Premium+ 450 Builders Silicone – Translucent 300ml (Box of 25) 
OX Pro Brick Carrier 
Hambleside Danelaw TV15/1 Flush Fitting Tile Vent - Antique Red (Box of 5) 
OX Pro Top Steady Nail-On (Full Kit) Clamp Set 
Everbuild 709 FebFlor Floor-Flex Plus - 5 Litre 
Freeflow 65mm Square Gutter Drain Pipe 112° Branch - White 
Code 4 Cast Lead - 600mm x 3m 
Gorilla Tape - Black (48mm x 32m) 
Code 5 Cast Lead – 650mm x 6m 
Bond It Rubber Bitumen Emulsion - Black 2.5L 
OX Trade XL Cuts All Tiles Diamond Blade 
Thompson's Stain Block Damp Seal - White 250ml 
Bond It PVA & Adhesive Sealer - White 500ml 
ALM Code 6 Milled Lead Flashing - 800mm x 6m 
Freeflow 112mm Round Union Gutter Bracket - White 
Timco Impact Driver Bit Set 
Everbuild Everflex Premium+ 565 Clean Room Silicone – White 295ml (Box of 25) 
Soudal Degrip All Spray – 300ml 
Easy-Trim Lead R Flashing Textured – 600mm x 5m 
ALM Code 8 Milled Lead - 850mm x 3m 
FloPlast Square to Round Downpipe Adaptor - Black 
Ronseal Interior Varnish - Clear Gloss 2.5L 
OB1 Grip & Grab Waterproof Adhesive 
Ronseal Crystal Clear Outdoor Varnish is an outstanding product with an innovative formula that delivers excellent sealing properties without changing the colour of the surface. This high-quality varnish seals the surface, providing excellent water-resisting properties and highlighting the natural wood.
Preparation
To ensure an optimal finish on previously stained or varnish wood, you should sand down the surface using 120-grit sandpaper, working in a circular motion to remove any old varnish or stain. After sanding the surface, use white spirit and a cloth to clean the surface from dust.
When applying to new wood, you should lightly sand the surface using 120-grit sandpaper, ensuring there is no imperfection on the surface. After, use white spirit and a cloth to clean the surface of any leftover dust.
Application
- Open the tin and thoroughly stir it, ensuring no lumps are in the varnish
- Using a brush, apply the varnish brushing in the direction of the wood grain
- Allow six hours to pass for the coat to dry
- To achieve optimal results, you should apply three coats, but before applying the final coat, lightly sand the surface
Aftercare
After the varnish has dried, you can maintain the quality of it by cleaning the surface, ensuring that no grime or dirt builds up. Any tools used during the application process can be cleaned using warm, soapy water. If you notice any damage to the surface, lightly sand the surface and apply the varnish to it.
