Code 8 Cast Lead - 300mm x 6m 
Thompson's Emergency Roof Seal - Black 1L 
Everbuild Everflex Mirror Mate Adhesive - White 290ml 
Easy-Trim Lead R Flashing Smooth – 600mm x 5m 
ALM Code 7 Milled Lead - 914mm x 6m 
Samac Half Round Snowguard Bracket - 150mm (6") 
Klober 20K Slate Vent KG9795-0429 Slate Grey 
Ronseal uPVC Paint - Royal Blue Satin 750ml 
Everbuild General Purpose Silicone - Clear 280ml (Box of 12) 
Everbuild Black Jack 908 DPM – 25 Litre 
Everbuild Opti-Mix Mortar Plasticiser - 1 Litre (Box of 12) 
Code 6 Cast Lead - 240mm x 6m 
Left Hand Klober Contract Dry Verge Unit Brown 
Klober Thin Line Vent - Black KG9855-3-0450 (Box of 10) 
Everbuild ASBO Graffiti Remover - 400ml 
Azpects EASYSeal Sandstone Enhancer and Sealer 5L 
ALM Code 5 Milled Lead - 1600mm x 6m 
Klober Small Slate Vent - Slate Grey 
Ronseal One Coat Stays White Radiator Paint - Gloss 750ml 
Klober Thin Line Vent - Terracotta KG9855-3-0152 (Box of 10) 
Bond It Multi-Purpose Low Viscosity Spray Lubricant - 400ml Clear 
Ronseal Crystal Clear Outdoor Varnish - Satin 2.5L 
FloPlast Square Union Unit - White 
Everbuild Tecnic Silicone 825 – Limestone White 380ml (Box of 25) 
Everbuild Everflex 125 One Hour Caulk Magnolia 300ml (Box of 25) 
Uses
The Stay Fresh by Soudal is the go-to sealant for areas of high humidity, including toilets, washrooms, bathrooms, kitchens, and anywhere moisture can build up. Soudal forged this product with a unique composite containing an elastic, neutral, silicone-based material that provides fantastic adhesion and flexibility. This product is commonly used in sanitary rooms, top sealing in glazing, cold store rooms, container constructions, and air conditioning systems.
Preparation
Before commencing the application, ensure the area is free from contaminants that can hinder the adhesion, including dirt, dust, grease, oil, organic growth, loose debris, etc. If the surface is porous, a primer can be applied to enhance the adhesion; non-porous surfaces can be sprayed with a surface activator.
Application
- Cut the top of the cartridge, taking care not to damage the threaded screw.
- Cut the nozzle at a 45° angle with an opening slightly larger than the gap to be filled.
- Place the cartridge into a suitable applicator tool.
- Point the tip of the nozzle to the gap and apply one long singular bead across the gap.
- After applying the material, tool it down to a smooth, professional finish.
Limitation and Notes
- This product is not suitable for contact substrates such as natural stone, polycarbonate, bitumen, tar or surfaces that release plasticisers.
- This product is not suitable for bonding aquariums.
- This product should be applied to areas subject to constant water immersion.
