OX Tools 600/1200/1800mm Pro Spirit Level Set with Bag 
Freeflow 112mm Gutter Internal Stop End - Black 
OX Trade Medium Red Carpenters Pencils - Pack of 10 
Ronseal One Coat Stays White Radiator Paint - Gloss 750ml 
OX Pro Brick Trowel Philadelphia Pattern - 10"/250mm 
Ronseal Diamond Hard Doorstep Paint - Tile Red Satin 250ml 
Hambleside Danelaw Felt Lap Vent 
Everbuild Black Jack 902 Bitumen & Flashing Primer – 5 Litre 
Timloc Double Pantile Tile Vent Terracotta (Box of 6) 
ALM Code 6 Milled Lead Flashing - 210mm x 6m 
FloPlast Side Fix Rafter Bracket 
Standard Brush 4-Inch 
Everbuild Everflex 125 One Hour Caulk Magnolia 300ml (Box of 25) 
Everbuild External Frame Sealant - Grey 290ml (Box of 12) 
Bond It Dec-Mate Flexible Filler - Magnolia EU3 
Bond It The Beast PU Adhesive - Brown 250ml 
Evo-Stik 528 Instant Contact Adhesive – 1 Litre 
FloPlast Half Round Fascia Bracket, Black – 112mm 
Bond It Contractors PVA - 1L White 
Everbuild B1 Hand Held Expanding Fire Rated Foam - Pink 750 ml 
Klober Small Slate Vent - Slate Grey 
Bond It Dec-Mate Flexible Filler - White EU3 
Ronseal Interior Varnish - Clear Satin 2.5L 
Everbuild Instant Nails – White 290ml 
Code 5 Cast Lead - 1200mm x 6m 
Thompson's Patio & Block Paving Seal - Wet Look 5L 
Everbuild PVCu Cream Cleaner - 1 Litre 
Timco Lithium EP2 Grease - 400g 
Uses
The 502 All Purpose Weatherproof Wood Adhesive By Everbuild is the perfect wood adhesive for all woodworking, joinery, furniture assembly and general household DIY applications. It's formulated with a water-based composite, making it an environmentally friendly product, delivered with a transparent, fast cure. A unique feature of this product is its suitability for curing through radio frequencies.
Preparation
Before commencing the application, check the wood to ensure it's in good health. Any signs of wet or dry rot must be removed and replaced or treated, and you can use the Ronseal Wet Rot Hardener if you would like to treat it before replacing it.
Application
- Apply a thin layer of adhesive to both surfaces and over-applying the glue will slow curing times
- Clamb surfaces together until the adhesive is dry, which can take up to 8 hours.
- When fitting dowels, the adhesive should be applied to the holes.
Limitation and Notes
- This product is not suitable for application in constant water immersion.
- Ensure wood doesn't contain excessive moisture (<15)
- Do not use at temperatures below 10°C
- Clean any excess adhesive by using a damp cloth during the clamping process before the glue has cured.
- Before staining or sanding, sand any excess glue off the wood.
- Ensure sufficient clamping pressure during curing, which is especially important with radio frequency bonding.
- It can be used with laminate strips, but it is not suitable for large areas of laminate.
- If applying this product externally, it's essential to protect all glue joints with an impervious paint system.
