Everbuild 501 PVA - 1 Litre 
Code 5 Cast Lead - 800mm x 3m 
Bostik Flashband Self Adhesive Flashing Tape – Grey 3.75m x 75mm 
Bondit Monster Mesh Pink 50m x 1m - 160g/m2 
ALM Code 5 Milled Lead - 390mm x 6m 
ALM Code 6 Milled Lead Flashing - 1600mm x 6m 
Timco Classic Pozi Multi-Purpose Screws - Mixed Tray 
ALM Code 3 Milled Lead - 600mm x 6m 
Klober Single Pantile Vent - Brown KG9860-0247 (Box of 10) 
Ronseal One Coat Water-Based Tile Paint - White Gloss 750ml 
Soudal Roof & Gutter Sealant – Black 290ml 
Code 6 Cast Lead - 450mm x 3m 
Soudal Silicone Sealant Remover, Clear - 100ml 
Code 7 Cast Lead - 1600mm x 3m 
Bond It Monster Water Resistant Tape - 48mm x 11m (Black) 
Soudal Gap Filler Expanding Foam Genius Gun 300ml - Champagne (Box of 12) 
Ronseal Stays White 2in1 Paint & Primer - Matt 750ml 
ALM Code 4 Milled Lead - 914mm x 6m 
Ronseal One Coat Damp Seal - White 750ml 
Everbuild Multi-Purpose Wood Filler - 250ml Dark Oak 
Everbuild Stick2 Industrial Superglue GP - Transparent 20g 
Timco Mixed Hose Clips 
Bond It Oil Stain Remover - White 1L 
Bond It All Weather Roofing Compound - Black 2.5L 
Soudal 5 Minute D4 Wood Adhesive Liquid – 750g (Box of 12) 
OX Pro Impact Bit Set - 11 Piece 
Bond It AS900 Acoustic Sealant - White 900ml 
OX Tools OXIT Sealant & Adhesive - Black 290ml (Box of 12) 
Bond It Mould Stop - Clear 5L 
Uses
This Everbuild All Purpose Ready Mixed Filler is essential for any D.I.Y enthusiast or Tradesman looking to repair various surfaces. This product dries to a smooth but tough, crack-resistant sandable finish, allowing you to perfectly repair a hole to a flush finish. This product is suitable for internal and external use, offering various areas of applications; this product is suitable for surfaces such as;
- Plaster
- Brick
- Wood
- Stone
- Render
Preparation
You must prepare all surfaces correctly to achieve a good key and optimal adhesion. Remove any dust, oil, dirt, grease or similar contaminants, cover any nail or screw heads with oil-based paint and allow to dry.
Application
- Stir well before use and apply directly from the tub into the filling area.
- This product can fill a gap with a maximum depth of 9mm. If you want to fill a more significant depth, apply in layers and allow 1 hour between each layer so it can fully cure.
Limitations
- Do not use to fill plastics or metals.
- This product is unsuitable to be applied when rain is imminent or within 5 hours of application.
- Do not apply in temperatures below 5°C.
- Not suitable for repairs in permanently wet areas
- Do not apply more than 9mm depth per application. (e.g. if the gap is 27mm deep, it will take 3 coats at 9mm depth each with an hour between each one)
