Soudal Soudafoam Gap Filler Hand Held 750ml (Box of 12) 
Siroflex Seal & Fix Hybrid Adhesive 
ALM Code 8 Milled Lead - 850mm x 3m 
Timco Anti-Slip Tape 
Code 5 Cast Lead - 240mm x 6m 
Evo-Stik Impact Adhesive - 500ml 
ALM Code 4 Milled Lead - 300mm x 6m 
Ox Pro Ultraflex Finishing Trowel - 16" (405mm x 110mm) 
Code 6 Cast Lead - 210mm x 3m 
Timloc Eaves Comb Filler 1m 
OX Tuff Carbon Marking Pencil Value Pack 
Klober Thin Line Vent - Black KG9855-3-0450 (Box of 10) 
FloPlast Half Round Internal Stop End, Brown – 112mm 
Everbuild KOS Fire Cement Buff – 2kg 
Everbuild Everflex 200 Contractors LMA Silicone - Brown 295ml 
OX Pro Tile Nippers 200MM / 8" 
OX Pro Brick Carrier 
Bond It PVA & Adhesive Sealer White 500ml - Box of 20 
Cromar Vent 3 Pro Breathable Membrane 1m x 50m 
ALM Code 5 Milled Lead - 1600mm x 6m 
Gorilla Contact Adhesive Tube - Clear 75g 
Everbuild Heavy Duty Multi-Use Wonder Wipes Tub (75 Wipes) 
ALM Code 3 Milled Lead - 800mm x 6m 
Everbuild Gun A Nail Standard – White 310ml 
ALM Code 7 Milled Lead - 760mm x 3m 
Gorilla Tape - Black (48mm x 32m) 
Code 7 Cast Lead - 600mm x 3m 
Code 8 Cast Lead - 1200mm x 6m 
Uses
The Dual Purpose Foam Cleaner by Everbuild is an effective, potent cleaner that removes uncured PU foam effectively. It's been crafted and equipped with a nozzle that allows application onto surfaces, tools and the PU Foam Gun itself. You can attach that to the PU Foam Gun to cleanse the inside.
Why does everyone who uses PU Foam need one of these? Because it's cost-efficient. This product delivers excellent cleaning properties that, if those using PU Foam don't utilise it, will result in their tools clogging up, getting damaged and becoming completely useless.
Preparation
The only preparation that is required for this product is ensuring the surrounding areas you are not cleaning are protected. The solvent-based formula in this product can attach to certain surfaces.
Application
Either;
- Screw the nozzle onto the top of the can, point at a surface or tool you want to clean and spray over it, allow the foam to dissolve and wipe
Or;
- Screw the can onto the PU Foam Gun, point at a direction you want to extrude the uncured foam into and squeeze the trigger. Let 5 minutes pass, and then squeeze again, repeating this process until 2-3 times, ensuring that only solvent residue is coming out.
