Timco Impact Driver Bit Set 
Sika AnchorFix®-1 Fast Cure Anchoring Adhesive System - Light Grey 300ml 
Ronseal One Coat Stays White Radiator Paint - Satin 250ml 
Bond It Rubber Bitumen Emulsion - Black 25L 
OX Pro Impact Drill & Drive Accessory Set - 40 Piece 
Freeflow Square Gutter System Gutter 135° Angle - White 
EVO-STIK Sticks Like All Weather Adhesive - Clear 290ml 
Bond It Trowel Mastic - Black 2.5L 
Ulti-Mate Stonewold Mk2 Roof Tile Vent - Grey 
Everbuild Stixall Extreme Power - Grey 290ml (Box of 12) 
Timco Mixed Plasterboard Fixings 
Timloc 5" Aero Core with Cowl & Baffle Terracotta 
Easy-Trim Lead R Flashing Smooth – 600mm x 5m 
OX Pro Grout Remover 
Soudal Trade Roof & Insulation Foam Genius - 600ml 
Bond It Monster Water Resistant Tape - 48mm x 11m (Black) 
ALM Code 4 Milled Lead - 390mm x 3m 
Everbuild Flexible Decorators Filler – 290ml (Box of 12) 
Timco Screwdriver 6-Tool Set 
Code 3 Cast Lead - 850mm x 3m 
Bond It Heavy Duty Gun Foam Applicator 
Uses
The All Weather Roofing Compound by Bond It is an excellent, general-purpose, high-performance, waterproofing compound that protects your roof from the environment. Its excellent formula allows it to resist water, drying into a tough, black coating. Its versatility is unmatched with it adhering to surfaces including;
- Asphalt
- Roofing Felt
- Corrugated Iron
- Fibre/Cement Slates
- Lead
- Copper
- Zinc
Preparation
Before commencing the application, you should ensure the surface is free from contaminants that can hinder the adhesion. Remove any dirt, dust, grease, oil, rust, and organic growth using a wire brush, fungicide, or rust inhibitor.
Application
- Stir the All Weather Roofing Compound thoroughly before using
- Apply to the surface via broom or brush
- Apply each coat at right angles to the previous one
- It should be applied to the surface at a maximum rate of 0.75 litres per m²
- Allow each coat to dry thoroughly before applying another; drying times can take up to 24 hours.
Limitation and Notes
- This product should not be used in areas subsequent to solvent contact
- Do not apply this product in potable drinking water tanks
- Ensure you allow sufficient drying time between coats.
- Bitumen naturally bleeds through paints, so a primer should be applied over the bitumen before painting.
