Everbuild Anchorset Green 300 - Grey 300ml (Box of 12) 
OX Pro Mortar Spike, 300mm 
Isoflex Special Primer - 750ml 
SikaFlex EBT+ Polyurethane Adhesive & Sealant, Brown - 300ml (Box of 12) 
Everbuild Gun A Nail Standard – White 310ml (Box of 25) 
Everbuild Black Jack 906 Bitumen Roofing Emulsion – 5 Litre 
ALM Code 3 Milled Lead - 240mm x 3m 
Everflex Galva Mate Duct Sealant - C3 
Ronseal 3 in 1 Mould Killer - 500ml 
Bostik Cementone PVA - 5 Litre 
Ronseal One Coat Damp Seal - White 250ml 
Soudal Trade PU Construction Adhesive - Beige 290ml 
OX Pro Nylon High Vis Builders Line 105m / 350ft - Cyan 
Everbuild Everflex Contract 125 One Hour Caulk – White 380ml 
FloPlast Half Round Line Pipe Socket, White 
OX Pro Impact Bit Set - 31 Piece 
Everbuild Silicone Eater Silicone Sealant Remover - 100ml 
Bond It Economy Sealant Gun - Blue 900ml 
Bond It Rubber Bitumen Emulsion - Black 2.5L 
OX Pro 6 Piece Bricklayers Set 
Klober Single Pantile Vent - Slate Grey KG9860-0429 (Box of 10) 
Everbuild Stick2 Hard Plastic Adhesive - 30ml 
Thompson's Patio & Block Paving Seal - Wet Look 5L 
Bond It Mould Stop - Clear 2.5L 
Everbuild P13 Plumbers Putty - Beige 750g 
Everbuild EB25 Ultimate Sealant & Adhesive – Grey 300ml (Box of 12) 
Everbuild 403 Concrete Hardener & Dustproofer – 5 Litre 
This Bond It Silicone Ultra Waterseal delivers impressive results preventing the ingress of rain and moisture into the wall, however, it does enable present water in the stone to evaporate from it, allowing your walls to be drier, warmer and help prevent future damages.
The uses of this product include being a general masonry waterproofer, suitable for application on brick, stone, concrete and unglazed tiles. Not only is water deflected and protected against, but also frost damage so that those cold winter months will have less of a toll on your building.
Application
Prepare all surfaces before application, this includes removing dirt, moss, lichen and any other organic growth that is present. If you find it challenging to remove particular organic growth, consider using Bond Its MOULD-STOP or PATIO-BLASTER as these are effective at eliminating these. If any fresh pointing is present, allow 24 hours for it to dry. All surfaces must be clean and dry before you start the application.
Do not use this product during rainfall, if rainfall is imminent, ensure you protect the are so it can cure properly. Do not apply this product on painted surfaces, however you can paint onto the surface after applying this product using breathable paints.
- Shake well before use.
- Apply using a low-pressure spray that isn't atomizing, or brush at a rate of 3m² per litre for porous stone and 5m² per litre for hard brick. Starting from the top and working your way down, making sure the surface is wetted well
- A second coat is required and should be applied when the masonry is still wet/tacky
