FloPlast Square Line Stop End Outlet White – 114mm x 65mm 
Sika Dustproofer – Clear 5 Litre 
Everbuild Pinkgrip SF But It’s White – 380ml (Box of 12) 
ALM Code 8 Milled Lead - 510mm x 6m 
ALM Code 3 Milled Lead - 390mm x 3m 
Everbuild Anchorset Green 300 - Grey 300ml 
Everbuild 703 Fix & Grout Tile Adhesive - White 750g 
Easy-Trim Lead R Flashing Textured – 450mm x 5m 
Freeflow 112mm Round Gutter System Stopend Outlet - White 
Bostik Flashband Self Adhesive Flashing Tape – Grey 3.75m x 75mm 
ALM Code 4 Milled Lead - 914mm x 6m 
ALM Code 5 Milled Lead - 360mm x 3m 
ALM Code 6 Milled Lead Flashing - 510mm x 6m 
Oxidised Bitumen Slab - 23kg 
Bond It Stain Block - 400ml Off White 
Everbuild Bath & Kitchen Sealant – White 290ml 
FloPlast Half Round Stop End Outlet, Brown – 112mm 
Easy-Trim Universal Dry Verge System - Grey 
OX Pro Moulding Bar - 10" / 250mm 
Thompson's One Coat Patio & Block Paving Seal - 5L 
Everbuild 405 Path & Patio Seal – 5 Litre 
Everbuild Everflex 200 Contractors LMA Silicone - Brown 295ml 
DeWalt 18V XR Compact Jobsite Blower Bare Unit - (DCV100-XJ) 
Soudal Soudafoam Hand Held One Shot - 150ml (Box of 12) 
Uses
The Dual Purpose Foam Cleaner by Everbuild is an effective, potent cleaner that removes uncured PU foam effectively. It's been crafted and equipped with a nozzle that allows application onto surfaces, tools and the PU Foam Gun itself. You can attach that to the PU Foam Gun to cleanse the inside.
Why does everyone who uses PU Foam need one of these? Because it's cost-efficient. This product delivers excellent cleaning properties that, if those using PU Foam don't utilise it, will result in their tools clogging up, getting damaged and becoming completely useless.
Preparation
The only preparation that is required for this product is ensuring the surrounding areas you are not cleaning are protected. The solvent-based formula in this product can attach to certain surfaces.
Application
Either;
- Screw the nozzle onto the top of the can, point at a surface or tool you want to clean and spray over it, allow the foam to dissolve and wipe
Or;
- Screw the can onto the PU Foam Gun, point at a direction you want to extrude the uncured foam into and squeeze the trigger. Let 5 minutes pass, and then squeeze again, repeating this process until 2-3 times, ensuring that only solvent residue is coming out.
