Everbuild Stick2 Rapid Epoxy Syringe - 24ml

Uses

Stick2 Rapid Epoxy Syringe is an exceptionally strong bonding two-part system that cures to a strength that can be drilled, sanded or painted. This product offers what most other adhesives don't, a glue capable of bonding almost any surface to another. It can be used for bonding;

• Metals
• Glass
• Wood
• China
• Dry Concrete
• Fabrics
• Rubber
• Crystals
• Jewellery
• Precious Stones
• Various Hard Plastics

Preparation

Prepare the surface before applying, and remove any contaminants hindering the adhesion. This includes; dust, oil, grease, general dirt and similar impurities. You can roughen the surface with sandpaper, and this optimises adhesion.

Application

1. Remove the cap from the top of the product and snap off the tab from the bottom of the nozzles.
2. Use the plunger to extrude equal lengths of resin and hardener onto a clean surface and place the cap back onto the product.
3. Mix thoroughly for 30 seconds to 1 minute using the stick provided.
4. Once mixed, use it within 4 minutes, applying small quantities at a time and immediately bringing both surfaces together.
5. Hold surfaces together firmly, and if needed, use clamps to support the curing process, which will take 10 minutes at 20°C

Limitations

• This product is unsuitable for repairing areas containing food or drink.
• Ensure you do not cross-contaminate the hardener with the resin, as it causes the tubes to cure inside.