Everbuild 402 Waterseal – 25 Litre 
Everbuild Multi-Stick Adhesive - White 350ml 
Samac Hall Hooks - (Bags of 10) 
Everbuild Forever Clear Silicone Sealant – 295ml 
Soudal Parquet & Timber Sealant - Dark Grey 290ml 
ALM Code 4 Milled Lead - 360mm x 3m 
Timco Lifting Sling 2000kg / 2 Tonnes 
Thompson's One Coat Concrete Seal - 5L 
Bond It Mirror Pro Adhesive - White EU3 
IKO 5U Eaves Protection Strips - 16m x 330mm 
Timloc Castellated Tile Vent Grey (Box of 8) 
Bond It Sealant Applicator Tool 
Ronseal Stays White Ultra Tough White Gloss Paint - 2.5L 
Ronseal Quick Drying Smooth Finish Filler - 600g 
Ronseal Stays White 2in1 Paint & Primer - Satin 2.5L 
Bond It Roof-Mate Roof & Gutter Sealant - Black EU3 
Everbuild PVCu Solvent Cleaner – 1 Litre (Box of 12) 
Cromar ProRidge Universal Ridge System 3m Kit 
FrogTape® Delicate Surface Masking Tape - Yellow 36mm x 41.1m 
Ronseal Super Flexible Smooth Finish Filler - 300ml 
Soudal Grip All Solvent-Based - 290ml 
Bond It Bitumen Paint - Black 5L 
Bond It FG8 Food Grade Silicone - White 310ml 
Freeflow 65mm Square Gutter Drain Pipe Shoe - Black 
Bond It Aluminium Foil Tape - 100mm x 45M (Box of 12) 
OX Pro Mini Square Mouth Shovel 
Soudal Soudafoam Window & Door Gun Grade – 750ml (Box of 12) 
Everbuild Industrial Superglue HV – Clear 20g 
Bond It Mega Stik PU Adhesive - Beige 750ml is a fast-curing adhesive foam. Designed specifically to aid in the installation of plasterboard, insulation boards, floorboards and roof decking.
It adheres well to most commonly used building materials: plaster, wood, metals, bituminous membranes and mineral wool and can even be used in place of backing rods in expansion joints and around window and door frames.
Preparation
Ensure to cover all surrounding surfaces with paper or plastic sheets to protect them from any drips of foam.
- The foam needs moisture to begin the curing process, mist the substrate with water prior to application
Application
When applying this product, make sure to wear gloves and eye protection at all times.
- If needed, warm the cans in some lukewarm water (not above 50°C) and shake for at least 30 seconds before fixing to the foam gun.
- Apply the beads to the substrate and leave for approx . 2 minutes before pressing into place. Hold board in place for around 1 minute until adhesive has began to cure.
- You should apply the boards in rows, starting from the bottom of the wall and working up to the top to avoid sliding.
Plastering can be done after 1 hour of application.
Limitations
- Cured foam is sensitive to direct sunlight and UV light so should be covered with an opaque sealant, filler, paint or other suitable material.
- Not recommended for use on polyethylene, silicone, oil and grease
