Everbuild Filler Coat – White 5 Litre 
Code 5 Cast Lead - 800mm x 6m 
Bond It Pro-Mate LMA Silicone - Translucent EU3 
Klober Universal Tile Vent Antique Red KG9854 (Box of 10) 
Soudal Sealant Remover – 400ml 
Cromar Vent 3 High Performance Breathable Membrane - 1m x 50m 
Everbuild 403 Concrete Hardener & Dustproofer – 5 Litre 
Ronseal One Coat All Surface Primer and Undercoat - White 250ml 
Ronseal One Coat Stays White Radiator Paint - Matt 750ml 
Everbuild Febond PVA - 2.5L 
Pinkgrip Dryfix Applicator Gun 
Soudal Adhesive Remover - 400ml 
Ronseal Precision Finish Brush - 1.5 Inch 
Armatool Leather Belt Black, Large 
Ronseal One Coat Water-Based Tile Paint - Black Satin 750ml 
Siroflex Seal & Fix Hybrid Adhesive 
Code 7 Cast Lead - 240mm x 3m 
Everbuild Black Jack 901 Black Bitumen Paint – 25 Litre 
Siroflex Contractors Lead Sheet Silicone - Grey 300ml 
Bond It Oil Stain Remover - White 1L 
Code 8 Cast Lead - 510mm x 3m 
Hambleside Danelaw TV15/1 Flush Fitting Tile Vent - Brown (Box of 5) 
FloPlast Half Round Square Line Gutter Adaptor - White 
Bond It Multi-Purpose Powder Filler - White 1.5Kg 
20 x Easy-Trim Ridge F Universal Dry Ridge System - 6m Kit 
Bond It Economy Sealant Gun - Blue 300ml 
Uses
The Everbuild 502 Wood Adhesive – 5 Litre is the perfect wood adhesive for all woodworking, joinery, furniture assembly and general household DIY applications. It's formulated with a water-based composite, making it an environmentally friendly product, delivered with a transparent, fast cure. A unique feature of this product is its suitability for curing through radio frequencies.
Preparation
Before commencing the application, check the wood to ensure it's in good health. Any signs of wet or dry rot must be removed and replaced or treated, and you can use the Ronseal Wet Rot Hardener if you would like to treat it before replacing it.
Application
- Apply a thin layer of adhesive to both surfaces and over-applying the glue will slow curing times
- Clamb surfaces together until the adhesive is dry, which can take up to 8 hours.
- When fitting dowels, the adhesive should be applied to the holes.
Limitation and Notes
- This product is not suitable for application in constant water immersion.
- Ensure wood doesn't contain excessive moisture (<15)
- Do not use at temperatures below 10°C
- Clean any excess adhesive by using a damp cloth during the clamping process before the glue has cured.
- Before staining or sanding, sand any excess glue off the wood.
- Ensure sufficient clamping pressure during curing, which is especially important with radio frequency bonding.
- It can be used with laminate strips, but it is not suitable for large areas of laminate.
- If applying this product externally, it's essential to protect all glue joints with an impervious paint system.
