OX Heavy Duty Soft Gel Filled Knee Pad 
Bond It Trowel Mastic - Black 1L 
Ronseal Crystal Clear Outdoor Varnish - Matt 250ml 
Double Nylon Tool Pouch with Belt 
Soudal Genius Gun Pipe & Plumbing Foam – 600ml 
Code 7 Cast Lead - 510mm x 3m 
Bond It Monster Wipes - White 75 Wipes 
Bostik Express Cement Pointing Mortar Buff – 310ml 
Soudal Multi Cleaner - 400ml 
Code 8 Cast Lead - 760mm x 6m 
Stanley Hi-Viz Tylon 5m/Ex19mm Tape 
Thompson's One Coat Waterseal - 2.5L 
Code 4 Cast Lead - 390mm x 6m 
Everbuild PVC Hazard Tape - Red/White (50mm x 33m) 
Ronseal Stays White 2in1 Paint & Primer - Matt 750ml 
Everbuild 209 Liquid Mortar Tone - Black 1 Litre 
Everbuild Black Jack 906 Bitumen Roofing Emulsion – 5 Litre 
Ronseal Stays White Ultra Tough White Matt Paint - 2.5L 
Samac Aluminium Clout Nails - 50mm x 3.35mm 10kg Box 
Easy-Trim End Cap Half Round - Black (Box of 10) 
Timco Round Wire Nails, Pack of 40 
ALM Code 8 Milled Lead - 300mm x 6m 
Bond It Expanding Foam Cleaning Fluid - Clear 500ml 
Everbuild Caulk Once – White 380ml 
Uses
The Black Jack Bitumen Roof Felt Adhesive by Everbuild is a high-performance roof-felt adhesive that utilises its oxidised bitumen-based adhesive. This allows it to be applied directly to the surface (Cold-applied), making it more straightforward for novice D.I.Yers. Besides roofing felt, this product is compatible with other substrates, including concrete, asphalt, wood, metal and similar surfaces.
Preparation
Ensure the surface is prepared correctly to achieve optimal results. Start by removing all contaminants that can interfere with the adhesion, including dirt, dust, grease, oil, etc. Any organic growth present should be removed using a dedicated mould remover, ensuring all spores are eliminated. A porous surface may be primed to help the Black Jack Roof Felt to adhere to it.
Application
BS 8217:1194 Is the British Standard for installing felt to a roof correctly; following these guidelines will optimise results.
- Apply the Roof Felt to the surface and allow it to be open for 15 - 30 minutes to develop its full tackiness.
- The felt should be placed on the wet adhesive carefully, either rubbing or rolling each section down to ensure maximum contact, focusing on removing any air that might get trapped.
- You should maintain pressure on the felt until it is cured fully, using a lighter roller that can apply approximately 25kg of pressure.
Limitations and Notes
- Do not apply to areas that are subsequent to contact with solvents
- Avoid inhaling any vapours in confined spaces
- On timber roof structures, you should follow BS 8217:1994 to achieve optimal results
