ALM Code 5 Milled Lead - 210mm x 6m 
Bond It B3 Fill And Fix Expanding Foam Aerosol - Beige 500ml 
Siroflex Painters Caulk-It - 380ml 
Code 3 Cast Lead - 150mm x 3m 
Code 7 Cast Lead - 760mm x 3m 
Bond It Aluminium Foil Tape - 50mm x 45M (Box of 24) 
Bond It FG8 Food Grade Silicone - White 310ml 
Soudal Adhesive Remover - 400ml 
ALM Code 7 Milled Lead - 150mm x 6m 
OX Pro Dry Wall Internal Corner Trowel - 102mm x 127mm 
Everbuild Aquaseal Liquid Roof – Slate Grey 21kg 
Code 4 Cast Lead - 510mm x 6m 
Everbuild Stixall Extreme Power - Grey 290ml (Box of 12) 
ALM Code 3 Milled Lead - 914mm x 3m 
ALM Code 8 Milled Lead - 180mm x 6m 
Standard Brush 2-Inch 
Everbuild Forever Grey Silicone Sealant – 295ml (Box of 12) 
Ronseal One Coat All Surface Primer and Undercoat - White 250ml 
Hambleside Danelaw Double Plain Tile Vent, TV10/9 - Slate Grey (Box of 5) 
Everbuild Patio Wizard – 1 Litre 
ALM Code 6 Milled Lead Flashing - 450mm x 3m 
Timloc Over Fascia Vent - 1m 
Code 8 Cast Lead - 450mm x 3m 
Easy-Trim End Cap Angled - Black (Box of 10) 
Code 6 Cast Lead - 850mm x 6m 
Ronseal One Coat Damp Seal - White 750ml 
Evo-Stik Liquid Nails Solvent Free - Buff 290ml 
Everbuild Multi-Stick Adhesive - White 350ml 
Bond It Saves Nails Instant Grab Adhesive - EU3 Beige 
Pinkgrip Dryfix Applicator Gun 
Uses
Stick2 All Purpose Clear Adhesive by Everbuild is excellent for bonding various surfaces together, and it can be used for most common household surfaces. However, it also includes;
- Ceramics
- Porcelain
- Wood
- Card
- Paper
- Most Plastics
- Leather
- Cork
- Linoleum
- Rubber
- Stone
- Glass
- Metals
- Dense fabric
Preparation
Ensure you prepare the surface before application; this is to optimise adhesion. Complete this by removing contaminants that can hinder the adhesion, such as dust, oil, grease etc.
Application
Porous Surface:
- Unscrew the cap and spread a thin, even adhesive layer onto one of the surfaces.Â
- Bring the surfaces together and hold them firmly.
Non-Porous Surface:
- Improve adhesion by abrading both surfaces with sandpaper
- Unscrew the cap and spread a thin, even layer of adhesive onto both surfaces
- Allow adhesive to dry to a tough tacky finish (5 - 10 minutes), then press firmly on both surfaces.
With both types of surfaces, the full strength of this adhesive is achieved within 24 hours with the temperature at 20°C
Limitations
- Will not stick polyethene, polypropylene or PTFE
- This product is not suitable for bonding acetate, rayon or items which contain a hot fluid
- Do not use this product near polish or some painted surfaces
- Do not apply this product to an area which is immersed in water
- This product is unsuitable for bitumen, asphalt, or cellulose-painted surfaces.
