Sika MultiSeal Self Adhesive Bituminous Sealing Tape - Grey (225mm x 10m) 
Klober Boll Roll Tile Vent KG6085, Brown 
FloPlast Half Round Gutter 90° Bend, Black – 112mm 
Ronseal Fence Life Brush - 4" 
Siroflex Trade Strength Medium Viscosity Superglue - 50g Roof Felt Adhesives
Best Sellers
-
OX Trade Fibreglass Handle Club Hammer
From: £14.69 Incl VAT £12.24 Excl VAT Select options This product has multiple variants. The options may be chosen on the product page -
Soudal Lead Sheet Sealant 290ml – Grey
£7.99 Incl VAT £6.66 Excl VAT Add to basket -
ALM Code 3 Milled Lead – 150mm x 6m
£36.82 Incl VAT £30.68 Excl VAT Add to basket -
You Save
£7.50
Easy-Trim Hip Support Tray Accessory Kit
Was:£32.99Incl VAT£25.49 Incl VAT £21.24 Excl VAT Read more -
Hambleside Danelaw Single Plain Roof Tile Vent TV10/5
From: £16.99 Incl VAT £14.16 Excl VAT Select options This product has multiple variants. The options may be chosen on the product page -
Buckbootz BVIZ2 Black/Orange High Visibility Waterproof Safety Lace Boot
From: £64.99 Incl VAT £64.99 Excl VAT Select options This product has multiple variants. The options may be chosen on the product page
Roof Felt Adhesives
Browse through our range of roof felt adhesives. At ERoofing, we stock a substantial range of high-quality felt adhesive that come in ranging sizes from 1 litre to 25 litre.
Applying Felt Adhesive
You must apply felt adhesive either using a stiff brush, mop or squeegee. To avoid thickening in cold weather, stock the felt adhesive in a warm room before — for more straightforward application.
Cromar Roofing Felt Adhesive, in particular, should be applied to the surface and left for 15 to 30 minutes (depending upon drying conditions) to develop its full thickness.
The felt should then be placed into the wet adhesive film carefully, rubbing or rolling each section down to ensure highest contact with the adhesive and to expel air trapped between the surface and the felt. Wherever possible, the felt should be unrolled into the roofing felt adhesive and rolled with a light roller (15 to 25kg).
The overlaps should be at least 75mm on the side and 150mm at the ends. To ensure a complete bond at the side and end laps, Cromar Roofing Felt Adhesive can be applied to the underside of the felt and well compacted.
When using with a timber structure, the first layer of felt must be nailed down. Successive layers of felt may then be bonded using Cromar Roofing Felt Adhesive.
When used on concrete surfaces that are porous, it will be necessary to prime the surface first, ensuring that the primer is completely dry before the first layer of felt is applied.
Twenty-four hours after laying felt, check all bondings to ensure that full adhesive has been obtained. Mainly check all laps.
